Tuesday, September 24, 2013

Bitty Butterfly & Elegant Butterfly Punch Bats

There has been an idea running around about how to use the Bitty Butterfly Punch and the Elegant Butterfly Punch to make bats. However, I have only seen it done using additional punches. So, I am going to share a quick tip on how to make the bats using only each butterfly punch itself. That's how I made the bats on the card below--this is literally a two minute card, very easy:


The rest is just some pictures, showing how to do this. I basically just punched out a butterfly, then put a dab of SNAIL adhesive of the back, tacked that to the edge of some scratch paper, and punched parts off the bottom of the punched pieces. Check out the pictures below to see where to line up your punch to take the "bite" out of the punched piece. If you don't punch enough, no worries--just slide it back down into the punch and "bite" off a little more :-)


You can see on the butterfly above, you actually want to cut up into the upper wing area just a little bit. For the butterfly below, you'll want to come in just right under the wings. Remember, take another "bite" with the punch if you didn't trim off quite enough the first time. I actually took a second tiny bite with this smaller butterfly to get the look I wanted.


DON'T FORGET...you can get the Bitty Butterfly Punch at 15% OFF through September 30, 2013 when you order it bundled with the Papillion Potpourri stamp set (get the bundle with either the wood-mount stamp set or the clear-mount stamp set).

~Kimberley Morris Colorado Springs, CO
Stampin' Up! Independent Demonstrator since 1994
procrastistamper@gmail.com
http://kimberley.stampinup.net (SHOP ONLINE 24/7!)
BECOME A DEMONSTRATOR
Connect with me on FACEBOOK
Connect with me on PINTEREST
Connect with me on TWITTER  
SUBSCRIBE to my Blog via EMAIL

2 comments :

  1. Ahhh, love the one punch way! Thanks for sharing.

    ReplyDelete
  2. Thanks for the inspiration, Cindee!!!

    ReplyDelete

Thanks so much for taking the time to comment! Comments are moderated and may take a while to show up...please be patient!

NOTE: If you would like to read any replies to your comment, please be sure you check the Notify Me box. If you would prefer an email response from me, please contact me at procrastistamper@gmail.com, as I do NOT receive an email address in association with your comment. Thank you!